当前位置:   article > 正文

[redis]DENIED Redis is running in protected mode because protected mode is enabledno bind address_node 192.168.37.128:7000 denied redis is running i

node 192.168.37.128:7000 denied redis is running in protected mode because p

具体报错信息

请添加图片描述

yield self.engine.open_spider(self.spider, start_requests)edis.exceptions.ResponseErrON: DENIED Redis is running in protected mode because protected mode is enabledno bind address was specified no authentication password is reouested to clients, in this mode connectionsare only accepted from the loopback interface, If you want to connect from external computers to Redis youmay adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SEprotected-mode no' from the loopback interface by connectina to Redis from the same host the server isrunning, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REIIRITE tomake this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redisconfiguration file, and setting the protected mode option to 'no', and then restarting the server. 3) If youstarted the server manually just for testing, restart it with the '--protected-mode no' option, 4) Setup abind address or an authentication passiord, NOTE: You only need to do one of the above thinas in order forthe server to start accepting connections from the outside.
  • 1

原因分析

保护模式或者绑定IP没有关

解决方法

方法一

这种报错首先要排除一下redis数据库的配置文件有没有关闭保护模式

# 我的配置文件在这个位置可能有不同
cd /etc/redis/
vi 6379.conf
  • 1
  • 2
  • 3

进入文件后找到

在 protected-mode 后面改为no

并且注释绑定ip

请添加图片描述
请添加图片描述

重启redis服务

# 配置文件是我自己改的名字具体根据个人
redis-server 6379.conf
  • 1
  • 2

如果还不可以

方法二

# 连接本地
redis-cli -h 127.0.0.1 -p 6379 
# 输入
config set protected-mode no
# 然后回车
即可解决
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
声明:本文内容由网友自发贡献,不代表【wpsshop博客】立场,版权归原作者所有,本站不承担相应法律责任。如您发现有侵权的内容,请联系我们。转载请注明出处:https://www.wpsshop.cn/w/盐析白兔/article/detail/698332
推荐阅读
相关标签
  

闽ICP备14008679号