- “Could not resolve host: mirrorlist.centos.org； 未知的错误“_could not resolve host: mirrorlist.centos.org; 未知的

: curl#6 - “Could not resolve host: mirrorlist.centos.org; 未知的错误”

14: curl#6 - “Could not resolve host: mirrorlist.centos.org; 未知的错误”

One of the configured repositories failed (未知),
and yum doesn’t have enough cached data to continue. At this point the only
safe thing yum can do is fail. There are a few ways to work “fix” this:

 1. Contact the upstream for the repository and get them to fix the problem.

 2. Reconfigure the baseurl/etc. for the repository, to point to a working
    upstream. This is most often useful if you are using a newer
    distribution release than is supported by the repository (and the
    packages for the previous distribution release still work).

 3. Run the command with the repository temporarily disabled
        yum --disablerepo=<repoid> ...

 4. Disable the repository permanently, so yum won't use it by default. Yum
    will then just ignore the repository until you permanently enable it
    again or use --enablerepo for temporary usage:

        yum-config-manager --disable <repoid>
    or
        subscription-manager repos --disable=<repoid>

 5. Configure the failing repository to be skipped, if it is unavailable.
    Note that yum will try to contact the repo. when it runs most commands,
    so will have to try and fail each time (and thus. yum will be be much
    slower). If it is a very temporary problem though, this is often a nice
    compromise:

        yum-config-manager --save --setopt=<repoid>.skip_if_unavailable=true
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25

Cannot find a valid baseurl for repo: base/7/x86_64
　　解决方式：vim

vim /etc/resolv.conf
1

插入：centos

nameserver 8.8.8.8
nameserver 8.8.4.4
1
2